SDS
CASTABLE TDEA75.5-11-M20 75A PART B NEUTRAL
Chemline Incorporated
1 PRODUCT AND COMPANY IDENTIFICATION
314-664-2230
CHEMTREC 800-424-9300 (24 HOUR SERVICE)
Chemline Incorporated
5151 Natural Bridge Road
Saint Louis, MO 63115
Supplier Details:
www.chemline.net
314-664-1355
Phone:
Emergency:
Web:
Fax:
2 HAZARDS IDENTIFICATION
Health, Acute toxicity, 4 Oral
Health, Skin sensitization, 1
Health, Serious Eye Damage/Eye Irritation, 2 A
Health, Specific target organ toxicity – Repeated exposure, 2
Environmental, Hazards to the aquatic environment – Acute, 1
GHS Classification in Accordance with 29 CFR 1910 (OSHA HCS):
GHS Signal Word: WARNING
GHS Hazard Pictograms:
GHS Hazard Statements:
H302 – Harmful if swallowed
H317 – May cause an allergic skin reaction
H319 – Causes serious eye irritation
H373 – May cause damage to organs ( state all organs affected, if known) through prolonged or repeated exposure (state
route of exposure if it is conclusively proven that no other routes of exposure cause the hazard)
H400 – Very toxic to aquatic life
GHS Precautionary Statements:
P261 – Avoid breathing dust/fume/gas/mist/vapors/spray.
P264 – Wash exposed skin thoroughly after handling.
P270 – Do not eat, drink or smoke when using this product.
P272 – Contaminated work clothing should not be allowed out of the workplace.
P273 – Avoid release to the environment.
P280 – Wear protective gloves/protective clothing/eye protection/face protection.
P280b – Wear protective gloves/eye protection/face protection.
P301 + P312 – IF SWALLOWED: Call a POISON CENTER/ doctor/ if you feel unwell.
P301 + P330 + P331 – IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
P303 + P361 + P353 – IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water [or
shower].
P304 + P341 – IF INHALED: If breathing is difficult, remove victim to fresh air and keep at rest in a position comfortable for
breathing.
P305 + P351 + P338 – IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present
and easy to do. Continue rinsing.
P314 – Get medical advice/attention if you feel unwell.
P330 – Rinse mouth.
P333 + P313 – If skin irritation or rash occurs: Get medical advice/attention.
Classification of the Substance or Mixture
GHS Label Elements, Including Precautionary Statements
Revision Date: 3/15/2018SDS Number: TDEA75.5-11-B-30000-M20 Page:1 / 5
P337 + P313 – If eye irritation persists: Get medical advice/attention.
P363 – Wash contaminated clothing before reuse.
P391 – Collect spillage.
P501 – Dispose of contents/container to …
Route of Entry:
Target Organs:
Inhalation:
Skin Contact:
Eye Contact:
Eyes; Skin; Respiratory system;
Heating, spraying, foaming or otherwise mechanically dispersing operations way generate vapor
or aerosol concentrations sufficient to cause irritation or other adverse effects. Minimal respiratory
tract irritation may occur with exposure to a large amount of material.
Prolonged or repeated exposure can cause skin irritation or dermatitis in some individuals.
May cause watering of the eye and irritation of the conjunctiva.
Ingestion: May cause nausea or vomiting.
Eyes; Ingestion; Inhalation; Skin;
Hazards not Otherwise Classified (HNOC) or not Covered by GHS
3 COMPOSITION/INFORMATION ON INGREDIENTS
Chemical Ingredients
CAS# Chemical Name
0
59719-67-4
102093-68-5
68479-98-1
%
90-100%
0-4%
0-3%
0-3%
Proprietary polyol blend
Carbamic acid, 1,6-
hexanediylbis-, bis[2-[2-(1-
methylethyl)-3-
oxazolidinyl]ethyl] ester
1,3-Benzenediamine, 4-
methyl-2,6-bis(methylthio)-
Benzenediamine, ar,ar-
diethyl-ar-methyl-
4 FIRST AID MEASURES
Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, oxygen should be
administered by qualified personnel. Call a physician or transport to a medical facility immediately.
Skin Contact:Remove all contaminated clothing and shoes. Wash skin with large quantities of water and soap. Wash
clothing before wearing again and clean shoes. If redness, itching or a burning sensation develops or
persists after the area is washed, consult a physician.
Eye Contact: Flush with large amounts of water for 15 minutes. Use fingers to assure that the eyelids are separated and
that the eye is being irrigated. Get immediate medical attention.
Ingestion: If swallowed, do not induce vomiting unless directed to do so by medical personnel. This material is an
aspiration hazard. Never give anything by mouth to an unconscious person. Seek medical attention.
5 FIRE FIGHTING MEASURES
Flash Point: >210 C
Flash Point Method: COC
Dry powder, foam, carbon dioxide. Use cold water spray to cool fire exposed containers to minimize risk of rupture. A solid
stream of water directed into hot burning liquid could cause frothing. If possible, contain fire run off.
6 ACCIDENTAL RELEASE MEASURES
Spill: Remove all sources of flames, heating elements, gas engines, etc. Emergency clean-up personnel should wear
chemical goggles, rubber or plastic gloves and clothing as required to protect against contact. Prevent spreading and
contamination of surface waters and drinking supplies. Notify local health officials and other appropriate agencies if such
contamination should occur.
Clean up: With adequate ventilation and appropriate personal protective equipment, cover the area with an inert absorbent
material such as clay or vermiculite and transfer to steel waste containers. Ventilate area to remove the remaining vapors.
Revision Date: 3/15/2018SDS Number: TDEA75.5-11-B-30000-M20 Page:2 / 5
7 HANDLING AND STORAGE
Handling Precautions: Do not smoke or use naked lights, open flames, space heaters or other ignition sources near
pouring, frothing or spraying operations. If contamination with isocyantes is suspected, do not
reseal containers. Special Emphasis for spray applications of mixed products containing
isocyanates: Inspect the application area for potential to expose other persons or for
overspray to drift onto buildings, vehicles or other property. When spraying building exteriors,
persons entering or exiting the building as well as those inside could be exposed to
polyisocyanates due to wind conditions, open windows or air intakes. Do not begin application
work until these potential problems have been corrected.
Storage Requirements: When stored between 60 -85 F in sealed containers, typical shelf life is 6 months or more
from the date of manufacture. Open containers must be handled properly to prevent moisture
pickup.
8 EXPOSURE CONTROLS/PERSONAL PROTECTION
Proprietary polyol blend cas#:(0) [90-100%]
Contains no substance with occupational exposure limits
Engineering Controls: All ventilation should be designed in accordance with OSHA standard (29 CFR 1910.94). Uses
requiring heating and/or spraying may require more agressive engineering controls or PPE.
Personal Protective
Equipment:
Proprietary polyol blend cas#:(0) [90-100%]
9 PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Non-Pigmented liquid.
N/A
None Flammable
<1
Flash Point:
Vapor Density:
Bulk Density:
>210 C
>1
8.61 lbs/gal
Spec Grav./Density:
Flammability:
Evap. Rate:
Physical State: Odor:Liquid Mild
10 STABILITY AND REACTIVITY
Reactivity: No specific data
Chemical Stability:
Conditions to Avoid:
Materials to Avoid:
Hazardous Decomposition:
Hazardous Polymerization:
Product is stable under normal conditions.
No specific data
No specific data
Under normal storage conditions hazardous decomposition products should not be produced.
Will not occur.
11 TOXICOLOGICAL INFORMATION
Proprietary polyol blend cas#:(0) [90-100%]
Finished product has not been tested.
May be harmful to aquatic life
12 ECOLOGICAL INFORMATION
Revision Date: 3/15/2018SDS Number: TDEA75.5-11-B-30000-M20 Page:3 / 5
Avoid exposing to the environment
13 DISPOSAL CONSIDERATIONS
Disposal: Any disposal practice must be in compliance with all federal, state and local laws and regulations. Chemical additions,
processing or otherwise altering this material may make the waste management information presented in this MSDS incomplete,
inaccurate or otherwise inappropriate. Waste characterization and disposal compliance are the responsibility solely of the party generating
the waste or deciding to discard or dispose of the material.
Do not allow material to enter sewers, a body of water, or contact the ground. Refer to RCRA 40 CFR 261, and/or any other appropriate
federal, state or local requirements for proper classification information.
14 TRANSPORT INFORMATION
Non DOT/Non RCRA regulated
IATA/IMDG/ICAO Not dangerous goods
15 REGULATORY INFORMATION
Component (CAS#) [%] – CODES
—————————————————————-
Proprietary polyol blend (0) [90-100%] IARC
Carbamic acid, 1,6-hexanediylbis-, bis[2-[2-(1-methylethyl)-3-oxazolidinyl]ethyl] ester (59719-67-4) [0-4%] TSCA
1,3-Benzenediamine, 4-methyl-2,6-bis(methylthio)- (102093-68-5) [0-3%] TSCA
Benzenediamine, ar,ar-diethyl-ar-methyl- (68479-98-1) [0-3%] TSCA
Regulatory CODE Descriptions
—————————————————————-
IARC = IARC Carcinogen Risks
TSCA = Toxic Substances Control Act
16 OTHER INFORMATION
Disclaimer:
Although reasonable care has been taken in the preparation of this document, we extend no warranties and make no
representations as to the accuracy or completeness of the information contained herein, and assume no responsibility
regarding the suitability of this information for the user’s intended purposes or for the consequences of its use. Each individual
should make a determination as to the suitability of the information for their particular purpose(s).
Health = 1, Fire = 1, Reactivity = 0, Specific Hazard = None
Health = 1, Fire = 1, Physical Hazard = 0
X – Consult your supervisor for special instructions
NFPA:
HMIS III:
HMIS PPE:
1
1
None
1
0
X
1
0
Revision Date: 3/15/2018SDS Number: TDEA75.5-11-B-30000-M20 Page:4 / 5
Revision Date: 3/15/2018SDS Number: TDEA75.5-11-B-30000-M20 Page:5 / 5