Safety Data Sheet
Revision Number: 006.0 Issue date: 10/14/2020
IDH number: 420481 Product name: FRKOTE WOLO PART NO. 83634 MOLD RELEASE AGENT
Page 1 of 5
1. PRODUCT AND COMPANY IDENTIFICATION
Product name: FRKOTE WOLO PART NO. 83634
MOLD RELEASE AGENT
IDH number: 420481
Product type/use: Mold Release Item number: 83634
Restriction of Use: None identified Region: United States
Company address: Contact information:
Henkel Corporation
One Henkel Way
Rocky Hill, Connecticut 06067
Telephone: +1 (860) 571-5100
MEDICAL EMERGENCY Phone: Poison Control Center
1-877-671-4608 (toll free) or 1-303-592-1711
TRANSPORT EMERGENCY Phone: CHEMTREC
1-800-424-9300 (toll free) or 1-703-527-3887
Internet: www.henkelna.com
Contains one or more components for which a Toxic Substances Control Act (TSCA) Low Volume Exemption (LVE)
applies. See Section 15.
2. HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
DANGER: HIGHLY FLAMMABLE LIQ UID AND VAPOR.
MAY BE FATAL IF SWALLOWED AND ENTERS AIR WAYS.
CAUSES SKIN IRRITATION.
MAY CAUSE DROWSINESS OR DIZZINESS.
HAZARD CLASS HAZARD CATEGORY
FLAMMABLE LIQUID 2
SKIN IRRITATION 2
SPECIFIC TARGET ORGA N TOXICITY – SINGLE EXPOSURE 3
ASPIRATION HAZARD 1
PICTOGRAM(S)
Precautionary Statements
Prevention: Keep away from heat, sparks, open flames, hot surfaces – no smoking. Keep container tightly
closed. No release into water. Use explosion-proof equipment. Use non-sparking tools. Take
action to prevent static discharges. Avoid breathing vapors, mist, or spray. Wash affected area
thoroughly after handling. Use only outdoors or in a well-ventilated area. Wear protective
gloves, eye protection, and face protection.
Response: IF SWALLOWED: Immediately call a physician or poison control center. If on skin (or hair):
Take off immediately all contaminated clothing. IF INHALED: Remove victim to fresh air and
keep at rest in a position comfortable for breathing. Call a POISON CENTER or physician if you
feel unwell. Do NOT induce vomiting. If skin irritation occurs: Get medical attention. Take off
contaminated clothing. In case of fire: Use foam, dry chemical or carbon dioxide to extinguish.
Storage: Store in a well-ventilated place. Keep container tightly closed. Store in a well-ventilated place.
Keep cool. Store locked up.
Disposal: Dispose of contents and/or container according to Federal, State/Provincial and local
governmental regulations.
Classification complies with OSHA Hazard Communication Standard (29 CFR 1910.1200) and is consistent with the provisions of the
United Nations Globally Harmonized System of Classification and Labeling of Chemicals (GHS).
See Section 11 for additional toxicological information.
IDH number: 420481 Product name: FRKOTE WOLO PART NO. 83634 MOLD RELEASE AGENT
Page 2 of 5
3. COMPOSITION / INFORMATION ON INGREDI ENTS
Hazardous Component(s) CAS Number Percentage*
Hydrocarbons, C7-C9, isoalkanes 1174921-67-5 60 – 80
Hydrocarbons, C10-C12, isoalkanes,
<2% aromatics
65072-03-9 30 - 60
* Exact percentages may vary or are trade secret. Concentration range is provided to assist users in providing appropriate protections.
4. FIRST AID MEASURES
Inhalation: Move to fresh air. If not breathing, give artificial respiration. If breathing is
difficult, give oxygen. Get medical attention.
Skin contact: Remove contaminated clothing and footwear. Immediately flush skin with
plenty of water (using soap, if available). If symptoms develop and persist, get
medical attention. Wash clothing before reuse.
Eye contact: Check for and remove any contact lenses. Rinse immediately with plenty of
water, also under the eyelids, for at least 15 minutes. Get immediate medical
attention.
Ingestion: Keep individual calm. Do not induce vomiting: contains petroleum distillates
and/or aromatic solvents. Never give anything by mouth to an unconscious
person. If vomiting occurs, prevent aspiration by keeping the patient's head
below the knees. Get immediate medical attention.
Symptoms: See Section 11.
Notes to physician: This material is an aspiration hazard. Potential danger from aspiration must
be weighed against possible oral toxicity when deciding whether to induce
vomiting.
5. FIRE FIGHTING MEASURES
Extinguishing media: Water spray (fog), foam, dry chemical or carbon dioxide. Do not use high
volume water jet.
Special firefighting procedures: Wear self-contained breathing apparatus and full protective clothing, such as
turn-out gear. Keep personnel upwind of fire.
Unusual fire or explosion hazards: Vapors may form explosive mixtures with air. Do not handle or store near an
open flame, heat or other sources of ignition. Hydrocarbon solvents are
basically non-conductors of electricity and can become electrostatically
charged during mixing, filtering or pumping at high flow rates. If this charge
reaches a significantly high level, sparks can form that may ignite vapors of
flammable liquids. Vapors may accumulate in low or confined areas, travel
considerable distance to source of ignition, and flash back. In case of fire,
keep containers cool with water spray.
Hazardous combustion products: Oxides of carbon. Hydrocarbons. Acrid smoke and fumes.
6. ACCIDENTAL RELEASE MEASURES
Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and
unprotected personnel.
Environmental precautions: Do not allow product to enter sewer or waterways. Advise authorities if product
has entered or may enter sewers, water sources or extensive land areas.
Prevent further leakage or spillage if safe to do so. This product is insoluble in
water and will float on surface.
Clean-up methods: Remove all sources of ignition. Ventilate area. Soak up with inert absorbent
material (e.g. sand, silica gel, acid binder, universal binder, sawdust). Store in
a closed metal container until ready for disposal. Keep upwind of the spilled
material and isolate exposure. Refer to Section 8 "Exposure Controls /
Personal Protection" prior to clean up.
IDH number: 420481 Product name: FRKOTE WOLO PART NO. 83634 MOLD RELEASE AGENT
Page 3 of 5
7. HANDLING AND STORAGE
Handling: During use and until all vapors are gone: Keep area ventilated - do not
smoke; extinguish all flames, pilot lights, and heaters; turn off stoves, electrical
tools and appliances, and any other sources of ignition. Make sure containers
are properly grounded before use or transfer of material. Prevent contact with
eyes, skin and clothing. Do not breathe vapor and mist. Wash thoroughly
after handling. Do not taste or swallow. For operations where eye or face
contact could occur, provide safety shower and eyewash fountain.
Storage: For safe storage, store between 5 C (41 F) and 25 C (77 F)
Keep in a cool, well ventilated area away from heat, sparks and open flame.
Keep container tightly closed until ready for use.
8. EXPOSURE CONTROL S / PERSONAL PROTECT ION
Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper
exposure controls and protective equipment for each task performed.
Hazardous Component(s) ACGIH TLV OSHA PEL AIHA WEEL OTHER
Hydrocarbons, C7-C9, isoalkanes None None None None
Hydrocarbons, C10-C12, isoalkanes,
<2% aromatics
None None None None
Engineering controls: Use explosion-proof mechanical ventilation and local exhaust to control
contaminants to within their occupational exposure limits during the use of this
product.
Respiratory protection: Use a NIOSH approved supplied air respirator with an organic cartridge if the
potential to exceed established exposure limits exists.
Eye/face protection: Safety goggles or safety glasses with side shields. Full face protection should
be used if the potential for splashing or spraying of product exists. Safety
showers and eye wash stations should be available.
Skin protection: Use chemical resistant, impermeable clothing including gloves and either an
apron or body suit to prevent skin contact.
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical state: Liquid
Color: Colorless
Odor: Mild, Solvent
Odor threshold: Not available.
pH: Not applicable
Vapor pressure: 12 mbar
Boiling point/range: > 112 C (> 233.6 F)
Melting point/ range: Not determined
Specific gravity: 0.725
Vapor density: Heavier than air.
Flash point: 6 C (42.8 F) Tagliabue closed cup
Flammable/Explosive limits – lower: Not available.
Flammable/Explosive limits – upper: Not available.
Autoignition temperature: Not available.
Flammability: Not applicable
Evaporation rate: Slower than ether.
Solubility in water: Slight
Partition coefficient (n-octanol/water): Not available.
VOC content: 99.39 %; 721 g/l
Viscosity: Not available.
Decomposition temperature: Not available.
IDH number: 420481 Product name: FRKOTE WOLO PART NO. 83634 MOLD RELEASE AGENT
Page 4 of 5
10. STABILITY AND REACTIVITY
Stability: Stable under normal conditions of storage and use.
Hazardous reactions: Will not occur.
Hazardous decomposition
products:
Oxides of carbon. Hydrocarbons. Acrid smoke and fumes.
Incompatible materials: Strong oxidizing agents. Humid air. Water.
Reactivity: Not available.
Conditions to avoid: Avoid static discharge. Vapors may form explosive mixtures with air. Spray mist may be
flammable at temperatures below the flash point. Keep away from open flames, hot surfaces
and sources of ignition. Fire or intense heat may cause violent rupture of packages.
11. TOXICOLOGICAL INFORMATION
Relevant routes of exposure: Skin, Inhalation, Eyes, Ingestion
Potential Health Effects/Symptoms
Inhalation: Vapors and mists will irritate nose and throat and possibly eyes. High vapor concentrations
(greater than approximately 1000 ppm) may cause headaches, dizziness, anesthesia,
drowsiness, unconsciousness, and other central nervous system effects, including death.
Skin contact: Causes skin irritation. May cause allergic skin reaction. Solvent action can dry and defat the
skin, causing the skin to crack, leading to dermatitis.
Eye contact: May cause irritation.
Ingestion: This product may be fatal if it is swallowed. Principal hazard of ingestion is aspiration into the
lungs and subsequent pneumonitis. Central nervous system depression, including dizziness,
drowsiness, fatigue, nausea, headache, unconsciousness.
Hazardous Component(s) LD50s and LC50s Immediate and Delayed Health Effects
Hydrocarbons, C7-C9, isoalkanes None No Data
Hydrocarbons, C10-C12, isoalkanes,
<2% aromatics
None No Data
Hazardous Component(s) NTP Carcinogen IARC Carcinogen
OSHA Carcinogen
(Specifically Regulated)
Hydrocarbons, C7-C9, isoalkanes No No No
Hydrocarbons, C10-C12, isoalkanes,
<2% aromatics
No No No
12. ECOLOGICAL INFORMATION
Ecological information: Not available.
13. DISPOSAL CONSIDERATIONS
Information provided is for unused product only.
Recommended method of disposal: Follow all local, state, federal and provincial regulations for disposal.
14. TRANSPORT INFORMATION
The transport information provided in this section only applies to the material/formulation itself, and is not specific to any
package/configuration.
U.S. Department of Transportation Ground (49 CFR)
Proper shipping name: Resin solution
Hazard class or division: 3
Identification number: UN 1866
Packing group: II
IDH number: 420481 Product name: FRKOTE WOLO PART NO. 83634 MOLD RELEASE AGENT
Page 5 of 5
International Air Transportation (ICAO/IATA)
Proper shipping name: Resin solution
Hazard class or division: 3
Identification number: UN 1866
Packing group: II
Water Transportation (IMO/IMDG)
Proper shipping name: RESIN SOLUTION (Isoalkane C7 - C10)
Hazard class or division: 3
Identification number: UN 1866
Packing group: II
Marine pollutant: Isoalkane C7 - C10
15. REGULATORY INFORMATI ON
United States Regulatory Information
TSCA 8 (b) Inventory Status: All components are listed as active or are exempt from listing on the Toxic Substances
Control Act (TSCA) inventory.
TSCA 12 (b) Export Notification: None above reporting de minimis
CERCLA/SARA Section 302 EHS: None above reporting de minimis.
CERCLA/SARA Section 311/312: Fire, Immediate Health, Delayed Health
CERCLA/SARA Section 313: None above reporting de minimis.
California Proposition 65: This product contains a chemical known to the State of California to cause birth defects or
other reproductive harm.
Canada Regulatory Information
CEPA DSL/NDSL Status: One or more components are not listed on, and are not exempt from listing on either the
Domestic Substances List or the Non-Domestic Substances List.
16. OTHER INFORMATION
This safety data sheet contains changes from the previous version in sections: 2, 3, 8, 11, 13, 15
Prepared by: Product Safety and Regulatory Affairs
Issue date: 10/14/2020
DISCLAIMER: The data contained herein are furnished for information only and are believed to be reliable. However, Henkel
Corporation and its affiliates ( Henkel ) does not assume responsibility for any results obtained by persons over whose methods
Henkel has no control. It is the user s responsibility to determine the suitability of Henkel s products or any production methods
mentioned herein for a particular purpose, and to adopt such precautions as may be advisable for the protection of property and
persons against any hazards that may be involved in the handling and use of any Henkel s products. In light of the foregoing,
Henkel specifically disclaims all warranties, express or implied, including warranties of merchantability and fitness for a particular
purpose, arising from sale or use of Henkel s products. Henkel further disclaims any liability for consequential or incidental damages
of any kind, including lost profits.
This Safety Data Sheet has been generated based on OSHA Hazard Communication Standard (29 CFR 1910.1200) and provides
information in accordance with U.S. federal law only. No warranty or representation of any kind is given with respect to the
substantive or export laws of any other jurisdiction or country. Please confirm that the information provided herein conforms to the
substantive export or other law of any other jurisdiction prior to export. Please contact Henkel Product Safety and Regulatory
Affairs for additional assistance.