615 S 4
th
Street, Elkhart, IN 46516-2717 Page 1 of 1
www.bigdogadhesives.com Ph: 833-BIG-DOGG (833-244-3644) December 2018
TECHNICAL DATA SHEET
1. DESCRIPTION:
BD5410 is a two-part, unfilled room
temperature cure, epoxy adhesive designed
for high speed bonding of metals,
ceramics, and most plastics. It cures to a
tough semi-rigid material, and is free
flowing in viscosity. It gives good
resistance to water, salt spray, inorganic
acids and bases, and most organic
solvents. It is especially formulated for a
1:1 mix ratio for use in side by side
cartridges, or to be used by hand mixing, or
use with Meter Mix Equipment.
A handling cure is normally achieved at
room temperature within 60 minutes with a
full cure at room temperature within 24
hours. To accelerate the final cure, or to
quicken the handling simply elevate the
temperature.
2. CHARACTERISTICS :
Room Temperature Cure Properties
Work Time: 8 to 12 minutes (at 75 F/ 24 C)
Fixture Time: 60 minutes (at 75 F/ 24 C)
Full Cure: 24 hours for full properties
Operating Temp. -40 F(-40 C ) to 266 F (130 C)
Mixed Density: 9.5 lbs/gal (1.15 g/cc)
Flash Point: Greater than 200 C (392 F)
Viscosity: Resin (Part A) 12,000 CPS
Hard (Part B) 20,000 CPS
Color: Resin (Part A) Clear
Activator (Part B) Clear
Mixed: Clear
Mix Ratio: 1 Part A to 1 Part B (1:1)
Hardness: 80 Shore D
Lap Shear Strength: > 2,300 PSI (AL to AL)
Tensile Strength: 6,500 PSI
Elongation: 5% to 10%
Impact Resistance: > 150 inch/lb
Water Absorption: < 1% (24 hours)
Dielectric Constant 4.5 (at 25C, 100Hz)
Dielectric Strength 410 v/mil
Volume Resistivity 8 x 10
14
ohm-cm
Shelf Life: 12 Months
VOC Content: 0% by weight
3. Handling and Storage:
A. Bring both components to room temperature prior to
mixing. Mix 1 part A to 1 part B thoroughly for 30 to
60 seconds.
B. Dispense mixed material over properly positioned
devices to be glued together. Do not pour more than
1/2 thick as the product may exotherm too high and
may boil. As this is a very quick adhesive, you must
work quickly to bond the pieces together.
C. Parts may be shipped within 24 hours but parts can
be moved in 1 hour.
4. ADDITIONAL INFORMATION
NOTE: Information contained herein is
based on tests we believe to be reliable and
accurate. It is offered in good faith for the
benefit of the consumer. The Company shall
not be liable for any injury, loss, or damage in
the use or handling of its chemical products
since conditions and use are beyond our
control. In every case, we urge and
recommend the user conduct tests to
determine to their own satisfaction that the
product is of acceptable quality and suitability
for their particular purpose under their own
operating conditions. Statements concerning
possible use of our products are not intended
as recommendations to use our products in
the infringement of any patent, or for any
particular purpose or application. These
products are intended for industrial use only.
BD5410 Epoxy Adhesive