Production method and quality control have been done in accordance with ISO 9001 standards. This information is presented in good faith, but
no warranty is given. These typical property values are intended to serve as guides only, and not as specification limits. Its user must determine
the suitability for any intended use of the material. No statements are intended or should be construed as a recommendation to infringe any
patent. The above testing results are subject to change according to the application and grade without prior notice.
TDS20180901 DATED: September 20, 2022
Page 1 of 2
12658 Cisneros Lane Santa Fe Springs, CA 90670 562.298.1300 FAX 562.298.1310
Coated Fabrics
CrystalForm
TECHNICAL DATA SHEET
PRODUCT INFORMATION
PRODUCT: Flexible Vinyl
PRODUCT ID: CFIT100150
EMBOSS: Orange Matte Vinyl
GAUGE: .006
COLOR: Orange
HAND: 44 PHR
WARNING
WARNING: THIS PRODUCT CAN EXPOSE YOU TO CHEMICALS INCLUDING DIISONONYL PHTHALATE
(DINP), WHICH IS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, AND DI(2-ETHYLHEXYL) PHTHALATE
(DEHP), WHICH IS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND BIRTH DEFECTS OR OTHER
REPRODUCTIVE HARM. FOR MORE INFORMATION GO TO WWW.P65WARNINGS.CA.GOV.
Production method and quality control have been done in accordance with ISO 9001 standards. This information is presented in good faith, but
no warranty is given. These typical property values are intended to serve as guides only, and not as specification limits. Its user must determine
the suitability for any intended use of the material. No statements are intended or should be construed as a recommendation to infringe any
patent. The above testing results are subject to change according to the application and grade without prior notice.
TDS20180901 DATED: September 20, 2022
Page 2 of 2
12658 Cisneros Lane Santa Fe Springs, CA 90670 562.298.1300 FAX 562.298.1310
Coated Fabrics
CrystalForm
PHYSICAL PROPERTIES
TEST
CHARACTERISTICS
UNIT of
MEASURE
TEST METHOD RESULTS
1. Gauge Tolerance % ASTIM D-1593 10%
2. Width Inch ASTM D-1593 115
3. Thickness (GA) After
Embossing
ASTM D-374C 10.82 GA
4. Specific Gravity 1.315 0.03
5. Tensile Strength kgf / cm
2
ASTM D-882
MD 210
CD 200
6. Elongation % ASTM D-882
MD 200
CD 220
7. Tear Strength kgf / cm
2
ASTM D-882
MD 60
CD 50
8. Shrinkage % %
ASTM D-1204
(100 C * 30 min * oven)
MD 60
CD 50
9. Cold Crack F / ASTM D-1790 32 / 0
10. Storage Conditions Rel. Humidity 40% – 60%
11. Shelf Life Ideal Conditions 12 Months
NOTES:
None.