Updated: 2018
Stabond C-160
Technical Data Sheet
DESCRIPTION
STABOND C 160 is a fast drying, VOC-free, high strength adhesive formulated for spray application.
PROPERTIES
TYPE: SYNTHETIC ELASTOMER THINNER: STABOND A THINNER
COLOR: TAN, RED, PINK COVERAGE: 120 FT /GALLON
SOLIDS: 25% VISCOSITY: 370 CPS
WT/GAL: 7.1 LBS BONDING RANGE: 3-15 MINUTES
SHELF LIFE: 6 MONTHS FLAMMABLE: YES
VOC(g/l): 0 APPLICATION TEMP.: 70 F to 100 F
APPLICATION
On porous materials, apply a uniform coating to both surfaces after they are thoroughly cleaned and free of oil, dirt or grease. Stabond
A thinner may be used for cleaning. Allow adhesive to become slightly tacky to the touch, then join substrates with good compression.
For optimum bond on non-porous materials make sure that the solvent has had sufficient time to evaporate before combining
substrates.
STORAGE
For maximum shelf life, store material in cool dry area and keep container tightly sealed. Storage temperature of 60 -80 F. are
recommended. Lower storage temperature will cause a temporary increase in viscosity. Rotate stock on a First in First out basis.
DANGER
Extremely flammable. Toxic. Vapors may ignite explosively. Provide fresh air cross ventilation to prevent build-up of vapors. Keep away
from heat, sparks and from open flame. Do not smoke. Extinguish all flames and pilot lights and turn off all non-explosion proof
electrical equipment and sources of ignition during use and until vapors are dissipated. Avoid breathing of vapors. Close container
after use. Contains acetone. KEEP OUT OF REACH OF CHILDREN. For detailed safety information related to this product read the SDS
prior to use.
IMPORTANT
Suggestions for the use of this product are based on tests believed to be reliable; however, the user should determine suitability for
the intended use by his own evaluation. Because the use of the material is beyond our control, neither the seller nor the manufacturer
shall be liable for any injury, loss, or damage, direct or consequential, arising out of the use or inability to use this product. Seller and
manufacturer s sole obligation shall be replacement of material proved to be defective.