25HP8105BF_TDS.pdf

E’ETECO^.
1000 South Linwood Avenue, Santa Ana, CA 92705
Phone: (714) 480-1370, Fax: (714) 558-1990
Date: 0611012002
Revision: 1111212002
HP 8105
Product lnformation
HP 8105 is a High Performance, rigid polyurethane foam designed for processing through plural
component, low or high pressure dispensing equipment or mixing and pouring by hand. Once fully
cured, this material is tough with high compression and tensile value. HP 8105 exhibits very good
surface characteristics and excellent moldability.
Physical Properties (Components)
Viscosity at 75oF (cps)
Specific Gravity (gr/ml)
Physical Properties (Final Product)
Compression Value (ASTM D – 1621)
Tensile Strength (psi), ASTM D-412
Elongation (%), ASTM D-412
Tear Strength (pli), ASTM D-624, Die C
Handling C haracteristics
Mix Ratio by Weight (A:B):
Mix Ratio by Volume (A:B):
Cream Time (seconds)
GelTime (at 75oF), (seconds)
Rise Time ( seconds)
Tack Free Time (seconds)
Demold Time (minutes)
Final Cure Time (hours)
Density
Component A
200 – 250
1.21 – 1.23
Component B
1000 – 1500
1.08-1.’10
63 psi
90 psi
3%
N/A
52t48
50/50
40-50
90 – 110
110 – 140
170 – 200
10-45
24
4.8 –
5.2
Storage and Shelf Life
Components A and B should be kept well sealed in a dry place at a temperature between 65 and
90oF. Shelf life of unopened containers is six (6) months from manufacturing date. Purge opened
containers with dry nitrogen before resealing. Refer to product MSDS for more information.
Packaging
Component A: 55 gallons steel drum (closed top)
275 gallons plastic bins
55 gallons steel drum (open top)
275 gallons plastic bins
500 lb Net Weight
2500 lb Net Weight
450 lb Net Weight
2250|b Net Weight
Component B
Non-Warranty: This information is furnished without warranty, expressed or implied, except that is accurate to the best
knowledge of Eteco, lnc. The data on these sheets relates only to the specific material designated herein. Eteco, lnc. assumes
no legal responsibility for use or reliance upon this data. The user should conduct sufficient investigation to establish the
suitability of any product for its intended use..