25RS1405AD_TDS.pdf

Product Information
Units Test Method Results
pcf ASTM D-1622-03 4.5 – 5.5
psi ASTM D-1620 85
psi ASTM D-1623 110
BTU-in/hr-ft
2
– FASTM C-177 0.18 – 0.20
% ASTM D-1940 > 93%
Units Component A Component B
(A/B) 50 50
(A/B) 52 48
g/mL 1.22 – 1.24 1.04 – 1.07
cPs 180 – 220 600 – 800
– Amber Beige
Seconds
Seconds
Seconds
Hours
Storage and Shelf Life
Packaging
Component A: 500 lbNet Weight
2500 lbNet Weight
Component B: 450 lbNet Weight
2250 lbNet Weight
Non-Warranty: This information is furnished without warranty, expressed or implied, except that is accurate to the best knowledge of Eteco, Inc. The
data on these sheets relates only to the specific material designated herein. Eteco, Inc. assumes no legal responsibility for use or reliance upon
this data. The user should conduct sufficient investigation to establish the suitability of any product for its intended use.
55 gallon steel drum (closed top)
275 gallon plastic totes
55 gallon steel drum (open top)
Rise Time
Tack Free Time
RS 1405
TECHNICAL DATA SHEET
Spray Rigid Foam Polyurethane System
Final Cure Time
3 – 4
10 – 12
18 – 22
24
Mix Ratio by Volume
Mix Ratio by Weight
Viscocity @ 75 F
Color
Cream Time @ 75 F
For more information contact Eteco, Inc. (714) 480-1370 | info@etecoinc.com
www.etecoinc.com
Components should be kept well sealed in a dry place from 70 to 90 F. Shelf life of unopened
containers is six (6) months from manufacturing date. Mix Component B well prior to each use. Purge
opened containers with dry nitrogen before resealing. Refer to product SDS for more information.
RS 1405 is a two-component CFC, HCFC and HFC free polyurethane foam designed for spray in place
applications. This formulation is recommended where thermal insulation, structural integrity and
environmentally friendly efficient products are required. RS 1405 spray in place foam system shall be
applied in half inch passes or less, maximum 1 inch passes, using standard plural component
polyurethane foam high pressure, impingement mix temperature controlled equipment.
*Properties are typical and not for specifications*
K-Factor
Handling Characteristics
Tensile Strength
Closed Cell Content
Physical Properties (Final Product)
Free Rise Density
Compressive Strength
275 gallon plastic totes
Specific Gravity @ 75 F