COR45-BA-131D
Vacuum Infusion Resin
Technical Data Sheet
INTERPLASTIC CORPORATION
3535 Latonia Avenue
Ft. Wright, Kentucky 41015-0519
859.292.7400 Fax: 859.292.7424
www.interplastic.com
COR45-BA-131D is a vacuum infusion resin. This resin is especially designed for resin transfer
molding and cold molding of filled composite materials.
LIQUID RESIN PROPERTIES RESULTS
Viscosity, Brookfield Model LV @ 77
o
F (25
o
C)
#2 spindle @ 60 rpm, cps 100 – 140
100 grams resin @ 77
o
F (25
o
C), catalyzed with 1.5 cc DDM-9*
Gel Time, min:sec 45:00 53:00
Gel to Peak, min:sec 20:00 – 32:00
Peak Exotherm 250 – 300
o
F
121 – 149
o
C
Non-Volatile, % 62 – 66
Revised: 8/18
All specifications and properties specified above are approximate. Specifications and properties of material delivered may vary slightly
from those given above. Interplastic Corporation makes no representations of fact regarding the material except those specified above.
No person has any authority to bind Interplastic Corporation to any representation except those specified above. Final determination of
the suitability of the material for the use contemplated is the sole responsibility of the Buyer. Our technical sales representatives will
assist in developing procedures to fit individual requirements, but all advice is accepted at your risk and should be checked for suitability
to your particular processes. These test data and properties are based on results obtained for a specific material under the specified
test conditions. They are not to be used as specifications and are not warranted as performance attributes for any product or system.
Specifications and properties of standard production material may vary slightly from those in this report. Interplastic Corporation makes
no warranties regarding any material and/or samples described in this report unless that representation is provided to your company in
writing by a Technical Director of Interplastic Corporation or one of his or her managers.