M A T E R I A L S A F E T Y D A T A S H E E T
FINISH KARE PRODUCTS, INC.
SOUTH EL MONTE, CALIFORNIA
sales@finishkare.com
(626) 443-8983
HAZARD RATINGS
_____________________________
MINIMAL……0 HEALTH 2
SLIGHT…….1 —————————–
MODERATE…..2 FLAMMABILITY 1
SERIOUS……3 —————————–
SEVERE…….4 REACTIVITY 0
—————————-
================================================================
=SECTION I PRODUCT IDENTIFICATION
================================================================
=
TRADE NAME: PART NO: V.O.C.
GRM/LT
MOLD SEALER & RELEASE AGENT……………………604-B
356.06
CHEMICAL NAME: HYDROCARBON MIXTURE
================================================================
=SECTION II HAZARDOUS INGREDIENTS
================================================================
=
OCCUPATIONAL EXPOSURE
LIMITS
CAS NO. % PEL/OSHA TLV/ACGIH VOC
LOW ODOR BASE SOLVENT 64742-47-8 35-55 5.0 MG/M3 200ppm
AROMATIC HYDROCARBON* 64742-95-6 15-25 * *
ALIPHATIC HYDROCARBON 8052-41-3 07-15 500PPM 100PPM
WAX BLEND 8015-86-9 25-30
* COMPONENTS- CAS # Max %
1,2,4, TRIMETHYL BENZENE 95-63-6 32.0 25 25
Xylene 1330-20-7 2.2 100 100
Cumene 98-82-8 1.5 50 50
================================================================
=SECTION III HEALTH HAZARD
INFORMATION
=============================================================================
=
THE HEALTH EFFECT NOTED BELOW ARE CONSISTENT WITH REQUIREMENTS UNDER THE OSHA
HAZARD COMMUNICATION STANDARD (29CFR 1910.1200)
EYE CONTACT: Product is minimally irritating to the eyes.
SKIN CONTACT: Prolonged or repeated contact may result in defatting and
drying of the skin.
INHALATION(BREATHING): N/A. Paste product.
INGESTION(SWALLOWING): Ingestion of product may result in vomiting;
aspiration (breathing) of vomitus into the lungs must be avoided as even
small quantities may result in aspiration pneumonitis.
EYE CONTACT: Flush the eye(s) with plenty of water for 15 minutes while
holding eyelids open.
SKIN CONTACT: Wash with soap and water.
MATERIAL SAFETY DATA SHEET (604-B) PAGE 2
=================================================================
SECTION IV EMERGENCY FIRST AID AND PROCEDURES
================================================================
=
INHALATION(BREATHING): N/A. Paste Product
INGESTION(SWALLOWING): Do not induce vomiting. If vomiting occurs
spontaneously, keep head below hips to prevent aspiration of liquid into the
lungs. Get medical attention.
================================================================
=SECTION V PHYSICAL DATA
================================================================
=
BOILING POINT: SPECIFIC GRAVITY: VAPOR PRESSURE:
318-388 F (H20=1) 0.797 (MM HG) 5.3 @ 100 F
MELTING POINT: SOLUBILITY IN WATER: VAPOR DENSITY:
250 F Negligible (AIR=1) 4.1
EVAPORATION RATE (N-BUTYL ACETATE=1) .13 ESTIMATED
% VOLATILE BY WEIGHT: APPROXIMATELY 65-70%
APPEARANCE AND ODOR: WHITE (HYDROCARBON ODOR)
=============================================================================
=
SECTION VI FIRE AND EXPLOSION HAZARDS
=============================================================================
=
FLASH POINT AND METHOD: 106 F PENSKY-MASTER CLOSED CUP
FLAMMABLE LIMITS/% VOLUME IN AIR: LOWER 1 UPPER 7
FIRE AND EXPLOSION HAZARDS: Containers exposed to intense heat from fires
should be cooled with water to prevent vapor pressure buildup which could
result in container rupture.
FIRE FIGHTING PROCEDURES: Do not enter confined fire space without full
bunker gear, including a positive NIOSH approved self-contained apparatus.
Cool fire exposed containers with water.
EXTINGUISHING MEDIA: Use water, fog, dry chemical or CO2. Do not use a
direct stream of water.
=============================================================================
=SECTION VII REACTIVITY
=============================================================================
=
STABILITY: Stable HAZARDOUS DEPOLIMERIZATION: will not occur.
INCOMPATIBILITY (MATERIAL TO AVOID): Avoid heat, sparks, flame and contact
with strong oxidizing agents.
HAZARDOUS DECOMPOSITION PRODUCTS:
=============================================================================
=SECTION VIII EMPLOYEE PROTECTION
=============================================================================
=
VENTILATION: Not required.
RESPIRATORY PROTECTION: Normally not required.
PROTECTIVE GLOVES: Normally not required.
EYE PROTECTION: Normally not required.
OTHER PROTECTIVE EQUIPMENT: Normally not required.
MATERIAL SAFETY DATA SHEET (604-B) PAGE 3
=============================================================================
=
SECTION IX ENVIRONMENTAL PROTECTION
=============================================================================
=
PRECAUTION IN CASE OF RELEASE OR SPILL: Eliminate potential sources of
ignition. Dike and contain. Soak up residue with an absorbent material such
as clay sand or other suitable material.
WASTE DISPOSAL METHOD: Dispose of in accordance with local, state and
federal regulations.
HANDLING AND STORAGE PRECAUTIONS: Handle as combustible liquid. Always wash
hands thoroughly after handling these products.( Protect from freezing, do
not storage on temperature above 851F)
=============================================================================
=SECTION X TRANSPORTATION REQUIREMENTS
=============================================================================
=
DEPARTMENT OF TRANSPORTATION CLASSIFICATION:
D.O.T. PROPER SHIPPING NAME: NON REGULATED
IMDG: FLAMMABLE SOLID,ORGANIC,N.O.S.(PETROLEUM DISTILLATES)LTD.QTY.
4.1/UN1325/PG III
OTHER REQUIREMENTS:
Emergency Telephone number: INFOTRAC 800-535-5053 and 352-323-3500
SARA SECTION 313 NOTIFICATION
I. Chemicals subject to the reporting requirements of Sara Title
III, Section 313 are identified in Section II Hazardous
Ingredients. Proposition 65 warning: (#)This mark following a
chemical listed in Section II designates material known to the
state of California to cause cancer, birth defects, or other
reproductive harm. Other ingredients may in addition contain trace
amounts of these known carcinogens or teratogens.
II. E.P.A. Sara Title III Section 313 listed toxic chemical is present as
follows: Not applicable
III. The information contained herein is based on the data available to us
and is believed to be correct. However, Finish Kare Products assumes no
responsibility for injury from the use of the product described
herein.
Date prepared: March 1, 2011 By: J. JHAVERI
BE SAFE…READ OUR PRODUCT SAFETY INFORMATION…AND PASS IT ON!