Updated: 2017
Stabond MR3
Technical Data Sheet
DESCRIPTION
Stabond Mold Release #3 has been developed to facilitate the removal of polyurethane parts from a mold.
PROPERTIES
TYPE: WAX SHELF LIFE: 12 MONTHS
COLOR: WHITE THINNER: STABOND T-THINNER
SOLIDS: 10% VISCOSITY: VERY THIN SYRUP
COVERAGE: 300 SQ. FT. /GALLON FLASH POINT: < 0 F
WT/GAL: 6.09 lbs
APPLICATION
The mold should be thoroughly cleaned and dried. Preheat the mold to 120 F. Either brush or spray the mold release to the warm,
dry surface. Then warm the mold and drive off the solvent by blowing air over the surface. The mold is now ready for use. Porous molds
e.g. Plaster of Paris, are not recommended, but if used, must first be sealed with lacquer or similar coating.
STORAGE
For maximum shelf life, store material in cool dry area and keep container tightly sealed. Storage temperature of 60 -80 F. is
recommended. Lower storage temperature will cause a temporary increase in viscosity. Rotate stock on a First in First out basis. For
optimum results agitate adhesive prior to use.
DANGER
Extremely flammable. Toxic. Vapors may ignite explosively. Provide fresh air cross ventilation to prevent build-up of vapors. Keep away
from heat, sparks and from open flame. Do not smoke. Extinguish all flames and pilot lights and turn off all non-explosion proof
electrical equipment and sources of ignition during use and until vapors are dissipated. Avoid prolonged or repeated breathing of
vapors. Close container after use. Contains aromatic and aliphatic hydrocarbons. KEEP OUT OF REACH OF CHILDREN. Harmful or fatal
if swallowed. If swallowed do not induce vomiting, seek immediate medical attention. THOROUGHLY READ THE SDS FOR THIS
PRODUCT PRIOR TO USING IT.
IMPORTANT
Suggestions for the use of this product are based on tests believed to be reliable; however, the user should determine suitability for
the intended use by his own evaluation. Because the use of the material is beyond our control, neither the seller nor the manufacturer
shall be liable for any injury, loss, or damage, direct or consequential, arising out of the use or inability to use this product. Seller and
manufacturer s sole obligation shall be replacement of material proved to be defective.